Does anyone know if it's possible to telnet to a 6800ia directly?Specifically I need to do a show inventory to get the SN of the SPF+ modules.You can do this from the console but not sure how to do it from the 6880
I had the same issue and found that two ports from my Cisco 9200 switch were plugged into an unmanaged non Cisco switch. The unmanaged switch was able to participate in Rapid Spanning Tree, so my switch blocked one of the ports as expected. However...
Followed this method from TAC and got my 6800ia switches working. 1. Check the FEX file and extract it into boot disk:dir microcode:Sh fex image bundle locationarchive tar /xtract microcode:FEX bootdisk: <<<< will extract .bin file from FEX ...