Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,I'm trying to configure a NM-CE-BP-80G-K9 and when I try to assign an external ip to it, it gives me the error below. I have previously done a password recovery, then a write erase to clear the config, then a reload on the module. The module ...
hello,I upgraded a CS-150-LAN-02 to the ap0610405 code. Upon reboot, I get the below error messages. If I boot back into the previous code (ap0401040s) I don't the errors. Is there a stair step that needs to be performed or is there something else...
Hello,I have a GSR 12008 and I'm getting the below error message below and I've been unable to find a symptom/solution. Has anyone encountered this and is there a fix for this? Thanks.Tim00:03:19: %ENV_MON-4-ONEPEM: Only one PEM is available in GSR
I have one power supply installed (tried it in both slots, but got the same error) below ist he show env & sh hardware..Router#show environmentSlot # Hot Sensor Inlet Sensor (deg C) (deg C)0 28.5 23.53 2...
