Hi Everyone, I've just come across a DMZ design by someone else for the first time so I will need some advice/opinion on this. From my knowledge, I'd separate the DMZ network and production servers onto 2 different network, 2 different physical inter...
Here's just a simple question that I don't have an answer to.Suppose that we have the following topology switch A - Router B - switch Call 4 ports connecting to each other are access VLAN 5If switch A sends out an arp request on VLAN 5 towards Router...
Hello All, I was reading the CCIE Routing and Switching Cert Guide V5 and came across the statement: iBGP peers do not share routes with each other in case of a routing loop, thus, all iBGP peers must form a full mesh within an AS. (without the confe...
Hello All,
I came to read the CCIE Routing and Switching Cert Guide v5.0 Volume 2 and having difficulty trying to understand the following command expression when referring an ACL in a route-map. To be more specific, the route-map is later used in
...
Hello All, I've been using FortiGate for my firewall choice and would recently like to switch to cisco ASA. one thing that I noticed from the FortiGate, is that it does not have ACLs, instead, it has something called Policy to filter the IPv4/IPv6 pa...
Thanks for the answer.I'd just need to clarify on my very last bit. From a router's point of view, 2 different local interfaces cannot have ip addresses belong to the same subnet unless bounded together.But a Layer 3 switch canwhat if I have on switc...
