I reset the switch and all ran well for a day. When connected to the CLI, it doesn't matter what command I run it always says, Unrecognized command. Additionally, it seems the IP on the switch which I'm assuming is because the DHCP lease ran out. ...
I have a switch that seems to be stuck in the factory reset sequence. I have removed power, applied power whilst holding in the mode button but it doesn't appear to do anything. I am connected via PuTTY and can see all of this happening in the CLI ...
I just don't think this is going to be the switch I need to practice CCNA commands. I purchased a used Catalyst 3550 and the commands seem to be responding well. Different IOS.
Yes,I finally got it working. I removed the front cover and found the reset button to be slightly bent. I straightened and reattached the cover. Was able to do factory reset and update to latest rev of ios. Thanks again!
I don't think you understand. I have already done as you suggested. It's as if the mode button is fully depressed without me touching it. It just keeps looping. Is it possible for the button to have been broken?
