Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i'm working with for the first time, I connected two C9200L-48T-4G in stack, they worked fine, the state before the issue was the following show switch stack-ports summarySw#/Port# Port Status Neighbor Cable Length Link OK Link Active Sync OK #Cha...
Hi all,I'm installing and setting up 2 Catalyst 9200L in stack for the first time, and I am some doubts about the correct configuration I have to do.I have to connect to them some stand alone servers and some servers with redundant NICs, I have to co...
Hi Balaji,I've just restarted the entire stack first, then only the second switch, unplug/plug again the stack cable.Following the sho ver Cisco IOS XE Software, Version 16.09.02Cisco IOS Software [Fuji], Catalyst L3 Switch Software (CAT9K_LITE_IOSXE...
