Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi team!I was wondering why this message is displayed when I'm trying to configure a SPAN Source: Error 400 - Span source and destination group combination not supported.I'm trying to replicate the EPG traffic (VLAN) which is passing through a VPC Li...
Hi there.In order to do a health check of ACI's nodes, I was trying to get the global temperature from each node by API REST.The output is similar to the 'show temperature' command:C220-FCH1807V02V /sensor # show temperature
Name Sensor Reading Units...
Hi there. Please, could you tell me if it's possible to get an ACI's backup by an API REST call an save it as a .tar.gz file in my local PC? I read that It is possible by an Ansible playbook, but what about an API REST call using ACI-Toolkit? Thanks ...
Hey team! I was wondering if you know how I could get the data that is displayed in a APIC dashboard System Health during the day.I would like to replicate that data in other format so I can attach it in a report.I found that I could get data through...
Hi! I reserved a IOS XE on Catalyst 9000 16.12 Code LAB.I connected to the VPN successfully but when I tried to connect to the device via SecureCRT, the terminal displayed the following message: 'Connection timed out'When I tried to ping the switch's...
I've tried to ssh the devbox, but it's unreachable too.Although the REST functionality was OK. I sent a request and I get a response in my IDE's terminal successfully . However, I needed to watch the CLI output in order to corroborate the response.
