Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a new C9200L-48PXG switch with IOS XE 17.3 (Amsterdam) which I need to downgrade to 16.9 (Fiji) in order for it to join an already existing StackWise cluster which all run 16.9.Based on the 17.3 release notes (https://www.cisco.com/c/en...
Hello, I would like to be double check to be on the safe side but is it possible to have different C9200L switch models inside the same StackWise cluster? I currently have a StackWise cluster of six C9200L-48T-4G switches and would like to add a C920...
Hello,I have a stack of two Cisco Catalyst C9200L switches (C9200L-48T-4G) one in active and the other in standby mode and noticed that they are both in BUNDLE mode. As I would like to upgrade the IOS from the current 16.9.2 to 16.12.05 I want to use...
Below you will find the full log starting from the afternoon on August 5. Some other weird behavior because the switch 1 rebooted last Friday at 21:32 for no obvious reasons and now it is as standby and switch 2 is now active. I really don't understa...
Here are the output of the commands requested above: sw#dir flash-2:
Directory of flash-2:/
8106 -rw- 2097152 Aug 5 2021 12:09:30 +02:00 nvram_config_bkup
8112 -rw- 2097152 Aug 5 2021 12:09:30 +02:00 nvram_config
40481 ...
It crashed again and now I have the full log from the buffer: Aug 5 15:29:15: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_NOT_PRESENT)
Aug 5 15:29:15: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_DOWN)
Aug 5 15:29:15: %R...
