Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
I'm having problem with my Catalyst 9200, I can't connect using Telnet or SSH but I can connect to the IP through other switch
This is my configuration!vrf definition Mgmt-vrf!address-family ipv4exit-address-family!address-family ipv6exi...
Hi everyone,I have Catalyst 9200 which I use for CCTV camera switch. The switch is connected with another switch Aruba and another Catalyst 9200. The problem that I have is : I cannot telnet from command prompt from command prompt to that main switc...
Hi everyone, I have a Catalyst 9200.I set the vlan inside the switch :vlan 11 -10.11.1.1 255.255.255.0vlan 91 - 10.19.1.1 255.255.255.0vlan 92 - 10.19.2.1 255.255.255.0vlan 93 - 10.19.3.1 255.255.255.0vlan 250 - 192.168.250.254 255.255.255.0 I set th...
The strange thing is today I can directly telnet to IP 10.11.1.5. I didn't add anything yesterday just trying every the suggestionsHere's my show run on the 10.11.1.5 today Building configuration...Current configuration : 11504 bytes!! Last configura...
10.11.1.1 is a switch core Cisco 4507 seriesI'm not running any ACL in 10.11.1.x, and I program the same thing for other switch but I can telnet the other switch
this is my logLog Buffer (4096 bytes):05:50:55 UTC Tue Nov 7 2023*Nov 7 05:52:10.438: IP: tableid=0, s=10.11.1.5 (local), d=10.11.1.1 (Vlan11), routed via FIB*Nov 7 05:52:10.439: IP: s=10.11.1.5 (local), d=10.11.1.1 (Vlan11), len 75, sending*Nov 7 05...
