Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,
I have configured DMVPN between HUB and Spook with spook having Dynamic ip (Nat behind local ADSL Router with dynamic ip). I have used OSPF as routing protocol. My DMVPN is also up, route is advertised in OSPF. I am able to ping lan IP co...
Hello All,
In My organization i have deployed wlc 5520 and there are 500+ users connected. I can see in my dashboard top connected clients and their current usage status. but i am unable to get report on current usage status for all connected clients...
Dear ALL,I am installing ASA 5516 with Boot and Sys Image of 6.0.0-1005. After installing The SFR Image by DAta PLANE went to Down Status. i Perfromed Rebot of The module but still issue reamins the same. i Have Attached Cureent Screenshot of the ima...
Dear All,
I have few(10 units) Cisco 1832 AP in my Clients Office. One Unit is acting as Controller while others are on Slave Mode. I have no issue to browse for internet using Mobile Devices as many as number till Cisco AP Can Supports the numbers b...
Hello, Need your assistance.
I have around 30 cisco 3700 Series AP. Recently i have upgraded to WLC firmware to 8.2.141.0. After upgrade my half of the aps are not able to join controller. When i console to ap, I found the ap are not getting ip from ...
There is route from firewall to 192.168.120.0/24 network to. Beside when i performed trace to servers hosted in my upstream firewall, Traffic get stuck in HUB only . Same is goes from firewall while performing trace to 192.168.120.0/24 which get stuc...
Hello Alekseev,
1.I have advertise default route from Spook towards hub and need to reach services/server hosted in my upstream firewall and also need to access internet from Hub only by Spook.
2. Spook is able to ping to all the local interface ip ...
