Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, I've attached a Zip file of the AutoCAD DXF for the brackets we had fabricated in Melbourne. The details of the brackets are also below:
-LASER CUT OUT OF 2MM MILD STEEL SHEET WITH NITROGEN-FOLDED 90 DEG ON BEND MARKS @ 20 MM-POWDER C...
Hi Michelle,
No, the brackets don't have the notches, however we've found there is plenty of support with the two screws. As the holes for the screws aren't countersunk, the screw heads do sit proud slightly (by ~1mm), however there is still enough t...
We've had no option but to have them fabricated. If anyone is interested in some of these and they're in Australia, we're doing an initial run of 80 and they'll be laser cut from mild steel sheet, folded, then powder coated white. We'll then source d...
The power is being automatically set. We haven't seen non-poe devices lose network connection as yet.We're only powering 3 Yealink PoE handsets plus 1 UniFi AP (802.3af) in one switch, and 1 Yealink PoE handset plus 1 UniFi AP (802.3af) in the other....
