Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having issues with calls getting dropped when a 7921G phone traverses from a WAP that is connected to Wireless LAN Controller A and transfers to a WAP on Wireless LAN Controller B. This is occurring with both of our 4402WLC and 2106 WLC. We ...
Is there any Cisco phone or IP based phone that works with the Cisco system that has the digital numbers on the hand receiver of the phone. This must not be wireless. i.e.) Hospital maternity ward is looking for a phone that would have the touch pa...
I'm trying to upgrade from 3.3.2 to v3.3.4 on a Windows 2000 server (SP4) and everytime I run the update it gives me a message about half way through:"The CiscoSecure ACS folder appears to be locked by another applicationC:\Program Files\CiscoSecure ...
I have AAA authenication working on our PIX and Switches with a backend Cisco ACS server. I'm able to login via Cisco Radius in enable mode on the Cat switches. Problem I have is I'm not sure of what is required to go right into enable mode on the ...
What actually fixed the problem was VLANs on the port channel between the cores on the network. I verify that on the WLC that LAG mode is also enabled.
On your devices and interfaces verifyCore to Core Port Channels - (This is where you have one 4402 or 2106 on one core and one on another core switch)interface Port-channel1 switchport switchport trunk encapsulation dot1q switchport trunk allowed vla...
On your devices and interfaces verifyCore to Core Port Channels - (This is where you have one 4402 or 2106 on one core and one on another core switch)interface Port-channel1 switchport switchport trunk encapsulation dot1q switchport trunk allowed vla...
The firmware upgrade going from 1.02 to 1.04 did not fix the problem. What actually fixed the problem was VLANs on the port channel between the cores on the network. Verify that on the WLC that LAG mode is also enabled.
We are on the same subnet and we haven't setup inter subnet roaming. I haven't checked and this is a good question. We will double check on this. Cisco TAC is getting us to upgrade the phone firmware as it's down two levels. TAC support says all ...
