Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just read the release notes for WLC update 5.0.148.0 and I saw this line:***Cisco Aironet 1000 Series Access Points-The 1000 series access points are not supported for use with controller software release 5.0.148.0***Our entire network consists of ...
Hello peopleI tried to update my WLC 4402 from 4.1.185.0 to 5.0.148.0 and ran in to some trouble, this is what I did:1. Took backup of WLC (Commands -> Upload files -> uploaded config to a server)2. Shut down WLANS3. Downloaded AIR-WLC4400-K9-5-0-148...
Hello folksI?m using WLC 4402 (v.4.0.206.0) with WCS 4.0.81.0When I create a new WLAN template in WCS and try and apply it to my controller I get this error reason: "SNMP operation to Device failed: Set for this object is not supported anymore"Why is...
HelloWe?re using WLC4402 with WCS 4.We are using MAC filters with WPA to limit which clients can connect.My problem is this:I think it is smoother to insert new MAC filters through the WLC web interface instead of using the WCS.When I do this the new...
Hello EricgarnelA couple of follow ups on that:1. I see that 1252 has 6 antennas, does this mean that these APs have a lot better coverage than 1010 and 1020 and I can get away with less APs ?2. We have a WLC4402-25 today and we're using one GB port ...
Ok, so you mean I can track one client at a time without the location appliance ? And by tracking I mean see where on the maps he is located, not only find out that he is connected to AP1.How do I go about to track one specific client ?
