Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.I am currently using WLC5520-8.10.196 and AP9115AXI in the office. I have noticed that some clients occasionally roam to farther APs. These clients are all Intel's WIFI6 network cards. The frequency band of AP is 80MHz.The AP3800 serie...
Hello,Now WLC has launched some 9115AXI and found that version 3.4 cannot recognize these APs. Should we upgrade each version one by one or can we directly upgrade across versions to 3.8 or 3.10
We are currently trying to reduce the transmission power of individual APs. Due to the fact that the network cable layout in the room existed several years ago, the placement of APs was not well considered. This experience has been a good accumulatio...
Yes, as circled in your picture, the WLAN is not configured with load balancing. Basically, 2.4 is turned off. Regarding the modification of the maximum TPC value, we will also try to create a new RF for experimentation. Thank you!
Thank you for your reply. Here is the layout diagram. APs are all attached to the wall facing the office, and most computers are equipped with WIFI6 network cards. For example, some people's computers may be located under AP3, but they may roam to AP...
