Hello all,
in windows 11 latest update, any connect 4.7.02036 fails to install with following message. error comes at mid of setup and rollbacks after error.
thanks for your suggestions.
Hi all,
did anyone done IPBase to Adv Enterprise upgrade for cisco ASR 1002-HX?
i found relevant part code is L-SLASR1-IPB-AES=. but didnt found any installation guide or clear ordering guide.
can someone help with required ordering parts and upg...
Hi All, can someone explain about packet injection (layer 2 and 3) idea and use case? i searched i different forms and didn't got a clear idea. thanks in advanceGK
Hi there,
can some one explain the OS and SQL licenses required for UCCX 11.5?
1 - am i need to purchase windows server 2016 licenses? or are they include in OVA
2 - am i need to purchase MS SQL licenses?
thank you
@justindabear
1. configure the router IDs to start ospf process
2. make sure your IP address in Host 2 is correct
3. make sure IP addresses between routers are in correct networks
4. check the routing table after OSPF neighbors joined
@ALI12 hi try this
https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01000100.html.xml
@lancesr hi, in standby mode, can you try to access CIMC? if it works, you can see the exact error details. also try to check any outputs in monitor. if you cannot see anything, most of the times, this meant to HW failure.