Hi Experts, I have some confusion in my mind about the following command with keyword filter-autorpcommand is - ip multicast boundary filter-rpNow my question is does filter-rp keyword denies RP advertisements also alongwith multicast scoping gr...
Yes you need to use Cisco ACE 4700 to load balance the requests to the applications or else you can use NAT in which you can use one vitual IP to access the two servers behind the NAT ip address.
It could be the error from one the three switches of the stack or from all three. Just check the hardware ports of all three switches. I think the problem might be in the hardware ports of the switches.Just check and let us know.Thanks
hi dear friend,In prefix-list /32 or /24 doesnt mean the wildcard bits dear.It means the network prefix & hence /32 means any mask over here.& 0/0 means only the default route.You can check this on dynagen software.
