Consider the scenario:CE1------CE2------PE1----PE2-----CE3---CE4CE2 and PE1, PE2 and CE3 have eBGP sessionCE1 and CE2, CE3 and CE4 have EIGRP sessionOn CE2 and CE3 there is a mutual red between EIGRP and BGP. If we inject route X from CE1 it reaches ...

Is there a way in EIGRP to determine exactly what routes are coming in from a particular interface. I know I can get the total number of routes coming in from an interface by the command "sho ip eigrp accounting" but I need to know what are these rou...

Apprecaite if somebody can answer the following: R1 (Multi-VRF CE)------------R2(PE) XYZ customer XYZ customer connects to R2 via PPPoE. Is there a way to assign XYZ customer a partiular IP address thru DHCP. The "host" command inside the dhcp pool d...

Is there a way to get the name of the router i.e. the router prompt with the interface address in the output of the mtrace command instead of just the interface addresses.R1#mtrace 1.1.1.1 2.2.2.2 239.1.1.1.Type escape sequence to abort.Mtrace from 1...

Is there any command available in IOS like ping/traceroute which gives the load on each interface it touches?