Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just like the title, I'm trying to configure it in gns3... but the l2tp tunnel won't active or up, also after exit the xconnect it shows an error below both in router 1 and router3R3(config-if)# xconnect 10.0.0.1 13 encapsulation l2tpv3 pw-class r3R3...
Hi, I'm new to CISCO,here my question, my boss asked me if we purchase the HSEC-K9 license... what is the maximum encrypted bandwidth (HSEC-K9)? ////Does it depends on the device specs right? our device; ISR4431 with SECK9 license... where theSECK9 l...
my dumb mistake,both interface facing to lan shouldn't have Ip, so the xconnect will completealso need to configure l2tp-classhope my mistake will help you guys... hehehehe this is for my fyp
Okay... first, a lot of thanks because of the reply to my question... So the conclusion, We can reach the max;5++Mb, if we purchase the HSEC-k9.. right? sorry, if I'm asking for too much... just need confirmation to show to my boss. btw, thanks again...
