if i consider as source SPAN port a trunk port, and as destination port a no-trunk port, will i see on this destination port the traffic no-tagged, right?I suppose that only if i configure the destination port as trunk port i will be able to se the t...

I know that IDSM occupied a slot on Catalyst 6000 and it permits to monitor traffic on a monitoring port directly on the backplane.So my questions are:-have i some limits in SPAN session, as i only have one destination port?-Can i monitor different t...

I have 2 switches 3548 in stack and i need to monitor ALL the traffic in the 2 switches (not only the traffic going thrught the 2 devices)I know that 3548 don't support RSPAN; I suppose i need to define all the ports on both switches in stack as sour...

i have a switch 3548. Actually if i need to define a SPAN session, all the port related to this session has to belong to the same VLAN.If i don't have VLAN defined, all the ports belong for default to the same VLAN?

i have 2 switch 6509 with MSFC and 2 switch 6513. These switches are connected in a trunk ring by 2 GE interfaces on every switch. All the same VLAN are defined on all the switches. I need to analyze traffic and i need to set VSPAN sessions. WIll th...