About maxclark

maxclark · 07-15-2007

Hello,When using the 53xx/54xx platforms to convert a TDM interface to SIP. How do you limit what IP addresses can send SIP calls to the appliance to be completed via the TDM connection?More specifically, when you have a phone connected to a SIP Rout...

maxclark · 04-04-2007

Hi all,The carrier is sending us 3 digits which will start with a 7, I need to change this so the pattern reaching the PBX starts with a 1. I have been looking at the translation rules and am assuming that there is something extremely easy that I can...

maxclark · 04-04-2007

Hi all,I have a 5350 with a voice TI PRI connected to it. I can make outgoing calls (Sip -> 5350 -> PRI) perfectly fine. When I dial on of my DIDs (PRI -> 5350) the 5350 is answering and giving dialtone to the user. When I remove the dial-peer voice ...

maxclark · 02-20-2007

Hi all,I am trying to configure netflow on a 6509 w/ Sup 720 3BXL to send accounting data to a management server. I have netflow configured (see below) and "ip route-cache flow" set on all of my major interfaces. Netflow data is being sent to the man...

maxclark · 01-31-2007

Hi all,I am trying to configure a GRE tunnel between two sites. In my configuration I have three Cisco routers. Router A and Router C are at the first site and are connected directly to each other - Router B is at the second site.We can create the tu...

maxclark · 07-19-2007

Hi,This isn't what I was looking for. I want to limit (via ACL?) what SIP devices can send traffic to the 53xx/54xx.Thanks,Max

maxclark · 04-04-2007

This was exactly what I needed. Thank you very much.

maxclark · 02-22-2007

Jan,I am using "show interface x" to get the interface statistics (also when we compare to snmp via cacti the netflow numbers are low). I am running nfsen (so netflow v. 1.5.2) on a FreeBSD box as my collector. Nfcapd command below as well.Thanks,Max...

maxclark · 02-22-2007

Jan,This definately improved the situation - however it looks like I am still getting truncated data (i.e. packets shows in the 200-300k range and when I look at the interface I am doing 800k+ inbound & outbound). Does the Sup aggregate or truncate d...

maxclark · 02-20-2007

Hi,Disabling CEF is definately not a direction that I can take - is there seriously no way to get full accounting out of this device?-Max

Member Since	‎01-26-2007 11:17 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	14

User Statistics

User Activity

Limiting Access to 53xx/54xx

5350 Sample Translation Rule

5350 PRI Outbound Works / No Inbound

Netflow Configuration

GRE tunnel works between routers, not external devices.

Re: Limiting Access to 53xx/54xx

Re: 5350 PRI Outbound Works / No Inbound

Re: Netflow Configuration

Re: Netflow Configuration

Re: Netflow Configuration