Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day-A local City provides free public WiFi at many of their parks. This topology includes:Meraki MR76, most of them 1 Gbps ethernet, 1 or 10 Gbps uplinks from access switches in parks to 10 Gbps at distribution layer to 100 Gbps to core layer o...
Good day-WLC 5520 is currently (LAG) multihomed to a pair of VSS Catalyst 6807 switches via a port channel. We are migrating off the 6807 to a VxLAN EVPN overlay on a pair of standalone Catalyst 9606 switches both connected via a Layer 3 /30 link. ...
Good day-I have a relatively new deployment of an RV325. When configuring PAT from public IP address to inside device, I have no problem doing this to a device on the LAN of 192.168.x.x. I have accepted the default suggestion for virtual IP address...
1750 router at each end with point to point T1 between the two. Data goes between sites fine. I have analog phone systems at each site, connecting to FXS card on each 1750. I can create the call fine over the T1, and can hear remote side, but they...
Thanks for the response, for certain!I agree - I was very surprised by the Bluetooth clients (most likely probes as aren't leveraging any Bluetooth functionality from the Meraki MR76 access points) ratio to connected WiFi clients.We're on the same pa...
Yes. I am certain of the Wireless and Bluetooth client counts. It was hard to believe but that’s what they were. I’m looking at one site (‘network’) in the Meraki dashboard at this time on a Monday afternoon and it shows:Wireless clients (status: ...
Thanks a ton for the response. Great information, for certain.Yes, we’d expect (literally) there are 10s of thousands of people in the park for certain events. There are two paths we’re looking at as follows:1 – What does the customer have for expe...
Thanks Scott! Awesome thoughts and this sounds exactly like what I'm looking for. Since I haven't done this, even in a lab environment, I'm guessing I need to configure (in GUI) Controller > General > 'LAG Mode on next reboot' to <DISABLED> and the...
I appreciate the reply. I don't think I was clear in my original post that I only have a single WLC in this environment so HA / WLC failover doesn't really apply here as we only have one WLC. I appreciate the reply, nonetheless. Cheers and Be Well....
