Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need advice regarding downloading the Local net user list from Anchor WLC or through WCS. In WCS I could not find any menu to generate a report on Local net users in other words Guest account list. Please advice ThanksJacob
I have WLC 4400/5508 I stumbled across this config paging disable command to stop page breaks, works great for the one session I am logged in but it do not work for other users..We want to apply this command globally? Is that possible ? Appericate al...
Hi All, I am facing a similar situation with Anchor Controller Wireless Network for Guest Access. We want to block application similar to one listed. Issues 1 - Unfortunately, a single WLAN can only accomodate 32 rules. Is there any possible solution...
I have a similar implementation with PI 1.3, over a MPLS network. The Bandwidth is over 100 Mbps between the sites although there are other Server's performing replication over the same circuit. I get the following errors, advise seekingNCS primary s...
Dante, we have similar issues with certain AP that the a radio show down although it is admin enabled. Check on your AP if that a radio is admin disabled then you might have to enable it.
Hi DanteWere you able to resolve the issue you had mentioned above. Do you think it has to do with the username / password admin got deleted. Keep posted thanks
