Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm assuming this is a Native IOS 6500 and you have applied a standard or extended RACLs (Routed Access Lists) on a physical or SVI (Switch VLAN Interface) interfaces. The reason why you don't see matches using the the "sh access-list" command is bec...
If you look closely your bottom 3524 switch is the Root bridge for Vlan 16. The Root bridge ID's MAC address and the Designated Bridge ID is the same MAC address of "00d0.0091.081f". So that tells me the the two Core Switches 1 and 2 have a higher b...
It appears you have your syslog level at 6 for VTP Pruning messages. I would simply just lower the level to 5 for these specific messages since they are only informational. Doing this will make them go away.Issue the following configuration command...
NBAR is only officially supported on the Cat6500 using a Sup32-PISA supervisor module. The PISA card has the capability to do NBAR in hardware up to 2GBpsThere is currently no Sup720-PISA option.Sup32-PISA Data Sheethttp://www.cisco.com/en/US/prod/c...