Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a new CUCM 14 Installation and I have the issue, when I dial out or get an incoming call that the + sign seems not be transmitted.For example I have create a Route Pattern which adds +491234 for example as outgoing Prefix and the calls i...
Hello,I have a Cisco UCS C220 M5SX and in the CIMC the embedded 1/10G NICs are not detected. The same is also on VMWare ESXi 7.03 Cisco Image.I have also added an i350 MLOM Card and the Card were only detected, if I set in the BIOS the Option "All On...
Hello,I have two Cisco 3802i-E Access Points were I need a higher power level on the 2.4 GHz WiFi that I will get a stronger singal, because I want to build a Mesh between them because I am not able to setup a cable on the other site.According to the...
The LOM Ports are now seems to be working an recognized by CIMC and also on ESXi, but the MLOM Card isn't recognized, if the LOM Ports are Enabled. If I disable the LOM Ports then the MLOM Card is working or is this a normal behaviour? Thanks.
The Cisco UCS C220 M5 isn't integrated to a UCS Fabric Interconnect. It is just connected to a normal Cisco WS-C3850-48U-E Switch.I have attached also Screenshots with MLOM in the Name, were you can see the Settings were the MLOM Card is detected wit...
The 5GHz signal is very weak at this place were the Mesh AP is placed. The 2.4GHz signal is able to get there. In the Mesh Settings I have changed the Backhaul Radio Type to 2.4GHz, so I think this should use the 2.4GHz instead of the 5GHz.The Aruba ...
OK I will check if I can get the access points with external antennas or maybe place the current Root AP to a other place were maybe the signal is a little bit better.I also noticed when I used my mobile phone at this place were the Mesh AP should be...
