Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! We have enabled second 5GHz radio on C9136. Mode client serving. No FRA. We observe that clients connect to second radio, which is good. I'm want to understand... why? Let me elaborate.From previous tests, we found (3800's, 9130's) that no client...
Hi everyone!Does anybody had experienced asymmetric Data rate vs Tx Data Rate? Using WiFiTools in Windows PowerShell:PS C:\WINDOWS\system32> monitor-wifistateDate&TimeStaeSSIDBSSIDAuthenticationReceive rate (Mbps)Transmit rate (Mbps)SignalChannel17.0...
Hi guys! Does any have found how to change channel width for 6GHz to ohter than "Best(DBS)"? 20MHz, 40MHz, 80MHz and 160MHz options are disabled when I created a new 6GHz rf-profile. Only con modify max width in "Configuration > Radio Configurations ...
Hi guys!Currently we have reports involving Apple devices. Low throughput is observed randomly. Devices does not disconnect from SSID. In fact, users can work normally until some activity demands more throughput (i.e Zoom or Teams meetings).WiFi info...
Hi Enes! Thanks for you answer. About "client steering", is it enabled by default? Where can I find this feature in the WLC? Is it the different from the classical "Load balance" found in WLAN Porifle? (I have that disabled)
Hi JPavonM,Thanks for your answer. The script in PowerShell basically arranges in columns the data obtained from "netsh wlan show interface". As soon as possible will capture traffic.Regards.
Hi Mir_One. I have a similar scenario. We have WLCs 5508, 8510 and 8540, APs from 3602 to 3802. Version 8.5.161.8 and 8.5.171.0. Did you find a solution?
