Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
BSTC-DAT-31-LAN6_SEC#sh int gi1/0/22GigabitEthernet1/0/22 is down, line protocol is down (err-disabled)Hardware is Gigabit Ethernet, address is a84f.b13e.8d96 (bia a84f.b13e.8d96)MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,reliability 255/255, t...
Hi,i am getting this error in Core Switch 6509 Model%EARL-SW2_DFC1-1-EXCESSIVE_PARITY_ERROR: EARL 0: Parity error detected in VRAM Kindly share the reason and Solution. Thank You
Hi,Can someone help with MAC flapping Issue in the Networks in 3 different Switches I have attached the Screen Shot also %SW_MATM-4-MACFLAP_NOTIF: Host 5254.4c83.09e0 in vlan 12 is flapping between port Gi1/0/19 and port Po1 I'm really confused why t...
when i type the command sh int gi 2/0/20 transceiver detail, i am seeing the error like below DOM is not implemented for the transceiver.Diagnostic Monitoring is not implemented. kindly me me to solve the problem.. Thank you in advance.
yesterday I did a shutdown and no shutdown for that port, so I was unable to check the reason today I have taken the error reason kindly advise further BSTC-DAT-31-LAN6_SEC#sh int gi1/0/47 status err-disabledPort Name Status Reason Err-disabled Vlans...
yesterday I did a shutdown and no shutdown for that port, so I was unable to check the reason today I have taken the error reason kindly advise further BSTC-DAT-31-LAN6_SEC#sh int gi1/0/47 status err-disabledPort Name Status Reason Err-disabled Vlans...
End Devices Phones are unable to communicate so is there any soultion how to Stop learning the mac address on the port? can you explain me what is use of enabling this command on the interface ? spanning-tree bpduguard enable
