Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are attempting to connect a C9200 (L2) switch to a C9500 (L3). Done this many times but for whatever reason, having issues with this setup. We have a direct fiber connection between the two. But receiving Amber light on the Rx side of the fiber ca...
I need the ability to manage Network B from Network A. Currently we have a physical link between the two switches and things are working fine. But Switch 1 in Network B is going away and it's an HP switch. It is being replaced by a Cisco switch. Wh...
Sorry, not fully understanding. You are saying I should hold off on using that new port config and instead check syslog? Or will those commands be fine with no spanning tree command in each? And yes we analyzed logs on both switches. Can't find a s...
Yes, I will try those configs tomorrow or next week and see how it goes. Wouldn't spanning tree command need to be used though on each port so I do not create some sort of loop?
