Hello All,
I have several AIR-AP1562E to deploy in MESH mode as MAPs.
My Controller is a 5520 running 8.3.150 code. I am limited to 8.5.X since I have older 3500 APs in the environment.
My main question is - Does the 1562 support mesh mode on 8.5.176...
Hello,I am using the built int windows supplicant. ISE 3.0 P4. I am using a 802.1x profile in windows.When I have the option "Connect automatically when this network is in range" Checked everything works and auths go through. But I have a specific ...
Hello all, I have built up over 22k random mac address endpoints. Is there a way to purge all the random mac addresses out of ISE anyone have an example rule or script for this?
Hello Community! I'm trying to design a way for a Guest account with AD credentials as an employee to login and after 2 hours be purged and forced to sign back in to the captive portal. This needs to be automatic without a sponsor. I only see options...
Hey all, not sure if there is a setting somewhere. But I enabled profiling service in preparation for wired 802.1x. I have static devices assigned to static group assignments for mab lists.When these devices are profiled they are removed from the mab...
When I untick autoconnect. and the user trys to connect before login, It says fails to connect to network. And in the ISE live logs those are shown above as the errors. A reboot or logoff didn't help. I do have 2 group policys for Auto and Manual con...
I am using machine and user authentication in the supplicant. On my policy I am using a was machine auth compound rule. So only the user auths if the machine did.Above that a pure Machine auth rule I am assuming its because the Computer is not conne...
I am about to embark on this as well, but replacing both my nodes due to only a 200gig drive. Those steps are what I had in mind as well. But for deleting the VM. I wondering if I can just create a fresh VHDX and install fresh from the iso.
