Hi, I need to change the power budget across the ports on this switch. Does anyone have a guide to change the poe budget for this switch (cisco cbs 350) preferably gui but CLI also if you could share the config and the sh commands to check the chan...
Hi
I am working through CCNA material which focusses on configuring and validation. This is great but I am looking to also remove the commands from the switch.
As an example (CCNA Etherchannel)
Configure with channel-group 1 mode on
Validate wi...
I have three routers and three subnets
Central router has the following ACL
access-list 20 deny host 185.140.150.1access-list 20 deny host 175.100.125.1access-list 20 deny host 192.168.10.1access-list 20 permit any
When i ping from 185.140.150.1 to...
Choose the size of the key modulus in the range of 360 to 2048 for your
General Purpose Keys. Choosing a key modulus greater than 512 may take
a few minutes.
How many bits in the modulus [512]: 2048
% Generating 2048 bit RSA keys, keys will be non-...
Switch(config-if)#shut
%LINK-5-CHANGED: Interface FastEthernet0/4, changed state to administratively down
Switch(config-if)#
Switch(config-if)#no shut
%LINK-5-CHANGED: Interface FastEthernet0/4, changed state to down
Switch(config-if)#
Switch(con...
No, solved it. The channel group must be shutdown before any commands are entered. Then change the int and then no shutdown brings the channel up with all interfaces having the right settings. It does not work unless you shut down first!
Group P...
I am now looking to correct it...sorry
okay so found the issue. Combining three Fa01-3 ports. This is the error message
*Mar 1 01:59:39.624: %EC-5-CANNOT_BUNDLE2: Fa0/3 is not compatible with Po1 and will be suspended (trunk encap of Fa0/3 is auto,...
okay so found the issue. Combining three Fa01-3 ports. This is the error message
*Mar 1 01:59:39.624: %EC-5-CANNOT_BUNDLE2: Fa0/3 is not compatible with Po1 and will be suspended (trunk encap of Fa0/3 is auto, Po1 is dot1q)
What I don't understan...
Okay so, int Fa0/1 does not sh up in sh vlan brief
VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa0/2, Fa0/3, Fa0/4, Fa0/5Fa0/6, Fa0/7, Fa0/8, Fa0/9Fa0/10, Fa0/11, Fa0/12, Fa0/1...
Okay so, int Fa0/1 does not sh up in sh vlan brief
VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa0/2, Fa0/3, Fa0/4, Fa0/5Fa0/6, Fa0/7, Fa0/8, Fa0/9Fa0/10, Fa0/11, Fa0/12, Fa0/1...