Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to upgrade ESXi nodes in a USCM cluster using Hyperflex Connect. Under the Upgrade navigation link, I select Upgrade. Then select ESXi, drop in the upgrade image (which validates successfully) and the vcenter credentials. It starts the...
During a Hyperflex Installer deployment, during the Deploy Validation phase, I'm getting this message:vCenter Reverse Proxy Port CheckvCenter reverse proxy at x.x.x.x is not reachable. Verify vCenter rhttpproxy port is open and set to 80. The springp...
During the Hyperflex Installer, 4.5(1a) ESXi, I am getting an error message, "Error: Firmware versions were not fetched" on the UCSM Configuration page. This is after the selection of servers page. This results in the UCS Server Firmware Version fiel...
Some more information from logs:2021-05-27-04:24:19.228;DEBUG;vCenter SSO URL obtained from vCenter: https://<host>/sts/STSService/vsphere.local.2021-05-27-04:24:19.228;DEBUG;Checking if the following HTTP URL is reachable: https://<host>/sts/STSServ...
I downloaded these two packages from Cisco Software and then added them to the FI with the Download Firmware option. Once they were on the FIs, the Hyperflex Installer was able to select them as a version.
