Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear People:)
I am about to finish my education and regarding that we are preparing a little setup.
This consists of 2 FW with a VIP and an internal network of 2 OSPF zones and 1 in DMZ, connected to 2 pcs of L3 switch.
We have to use OSPFv2 down...
Dear Cisco experts, I am new to networking and recently started an education within networking. I have a little setup where:Ip: 192.168.1.0 with VLSM split into 8 subnets (32,32,16,8,4,4,4,4).I have managed to setup DHCP from each of the 4 routers bu...
Hej BB,Thank you, I have made a little test in PT.I made and extra cabel but only with switchport mode trunk and allowed vlan 99, suddenly the hsrp formed.So in our setup I have to connect another cable between the 2 L3 switches where i purely allow ...
Thank you for the reply. I can ping from any of the end devices to their perspective routers which they are directly connected.I can even ping from router to router BUT when I try to ping from an end device to another routers device there is timeout....
