Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have a ASA 5510 add to my CCNA LAB.After I have the initial configuration on my ASA 5510. I can’t access ASDM via HTTPAny one can give me some advise ?The pc can ping 192.168.1.1, but couldn’t open the ASDM via httpHere is my show command...
Hi there,my topology is ISP-->home wireless wifi-->Cisco (R1)-->Cisco (R2)--> Cisco (R3)3 Cisco router running EIGRP, R1 can access internet, but R2 and R3 cannot access internet.my understanding is redistribute a default network into EIGRP, I tried ...
hi there,I bought a CCNA lab kit from eBay recently which included 3 routers and 3 switches.When I trying to connect router 2801 to 2811 with fast Ethernet port. Shows the status up and protocol down, I matched all the parameters are same. After tha...
Thanks for reply. still not working. Couldn’t access asdm via https://192.168.1.1.here is my sh run CCNAS-ASA# sh run: Saved:: Serial Number: JMX1603X0RT: Hardware: ASA5510, 1024 MB RAM, CPU Pentium 4 Celeron 1600 MHz:ASA Version 9.1(6)!hostname CC...
Hi Rick,thanks for reply. It is very cleared explanation.yes, R2 and R3 using the different subnet.I can see sh ip route on R2 and R3, these is a *EX route redistributed.don’t know how to do the home wireless wifi yet.Will working on it. a lot things...
