Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the latest firmware on both my switch and router. I have two patch cables between the router and switch and a LAG configured to bond them. I cannot get from active/standby to active/active even though I've been able to configure active/active...
My setup is a Cisco business 250 switch and a Cisco 240AC wireless access point. The MacBooks on the network are getting periodically disconnected, though they reconnect without any action from the user. It's enough, however, to interrupt streaming...
