Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneWe have an ASR1002-X and need to implement 44 NAT with the ratio of 4:1 (every 4 private address to 1 public IP NAT)I know there is a solution called "paired-address-pooling|, but the minimum ratio for this solution is 30:1 , (every 30 pri...
Hi everybodyI've nat configurations on my router and everything goes well .But in "show ip nat statistics" output , it shows some drops ( In-to-out drops: 3124 Out-to-in drops: 1136 )I dont know the reason and the meaning and I couldnt also find anyt...
Hi AllAnyone knows , is it possible to log ppp ip assignment to syslog ? (without using debug command)I mean logging ip assignment over the ppp phases from local pool to users via logging levels (0-7) in BRAS(ASR Router) without using debug command ....
Hi all I'm looking for a Cisco device in order to have large scale NAT (CGN).Anyone can advise me how to select suitable device (hardware) either any calculator application which can show what hardware would be suit.I've about 1Tbps traffic and about...
Hi All I've an ASR1002 which NAT some traffic.Since I check the translation table , some lines dont show anything about protocol and instead show "---" so too about outside local and global.(The red part in picture)Anyone knows what the story is ?Exp...
Sure ip nat pool cgnat 11.23.240.0 11.23.255.255 prefix-length 20 type rotaryip nat inside source list NAT pool cgnat Standard IP access list NAT20 permit 100.66.128.0, wildcard bits 0.0.63.255
Device is ASR1002-XIOS ver. XE 15.4(3)S3 When I clear NAT statistics counter, everything cleard except these counters (In-to-out drops and Out-to-in drops). And this device NAT IP traffic (fully IP)This is the configuration : ip nat pool cgnat 11.23....
