06-09-2021 10:09 AM - edited 06-09-2021 10:15 AM
Hi All
I've an ASR1002 which NAT some traffic.
Since I check the translation table , some lines dont show anything about protocol and instead show "---" so too about outside local and global.(The red part in picture)
Anyone knows what the story is ?
Exp : (Picture attached)
06-09-2021 10:17 AM - edited 06-09-2021 10:20 AM
Those are static NAT entries. There are no translations yet matching those static NATs, once a connection is translated an entry will be added to the translation table and the outside local/global addesses will be added.
06-12-2021 01:21 AM - edited 06-12-2021 02:20 AM
Hi @Rob Ingram Rob
Thankyou so much for your reply.
But I dont have any configuration regards STATIC NAT in this device .
06-09-2021 01:21 PM
below troubleshoot will help you :
https://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/8605-13.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide