Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a couple of Cisco SG350XG-24F which are in layer 3 mode with a number of VLANs setup. When using SNMPv2 to monitor I can add SNMP traffic sensors in PRTG for each of the VLAN IDs though these only show zero for traffic counters. Adding t...
Hi, The Pix 501 that has been in place for quite some time acting as a firewall between two LANs LANA - ip address outside 192.168.45.241 255.255.255.0LANB - ip address inside 192.168.44.240 255.255.255.0 This config has worked ok as devices in each ...
The other router is the ISP gateway. It only knows about the 192.168.44.0/24 network. I think Nat would need to be done on the Pix to masquerade 192.168.45.0/24 behind 192.168.44.240 interface address when traffic is destined for the Internet as thi...
