Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have established OSPF neighbors with ASAv and routers Outside, dmz_b, inside_1 and inside2.Each router has its own loopback interface from 1.1.1.1 to 4.4.4.4 as below showed. But 3.3.3.3 cannot establish OSPF neighbor of ASAv. But I have advertise...
I did the same test on VMware, I found the same issue as yours. I could not find any evidence to show MST can or cannot run over Ethernetchannel. 5 years passed, seems like there is still no answer, lol
Hi Balaji, Much appreciated. After no route outside 0.0.0.0 0.0.0.0 192.168.244.2 1route outside 0.0.0.0 0.0.0.0 202.200.200.1 1Inside router can ping 8.8.8.8 successfully. May I know why this works?I will research the solution carefully. Thanks agai...
Hi Balaji, Do I need to configure the ip nat outside? It's an incomplete command. I configured other stuff as you pointed out.Outside#show run | b natip nat inside source list internet interface Ethernet0/1 overload Outside#show run ip access-list st...
Hi Balaji, Thanks for your help again.Outside Router can ping 8.8.8.8 successfully, this function is already implemented by VMware virtual network adapter.Outside#ping 8.8.8.8Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, t...
