Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,Meraki's default option for licensing is co-termination. So at the time of deployment, we used this method, but now we want to change the license method and use a per-device license method.So please assist if anyone has done so before.
Hello Experts,APIC displaying the fault F0103. I searched some community discussion about this which determine that it's a bug CSCuv63617.Bug Link: https://quickview.cloudapps.cisco.com/quickview/bug/CSCuv63617. How can we mitigate this bug without d...
Hello Expert,I am going to configure the SSL certificate in ACI. So please help me with the below queries:After creating Key Ring, I select the 'Create Certificate request'. At this step, Cisco doc. says we have to use FQDN in Subject. So my question...
Hello,We are going to deploy NDO only deployment for Multi-site so,Could you help me with the below points regarding ACI, Nexus Dashboard, and NDO?1. For Data interfaces what configuration is required?2. We are using the same node id of the leaf and ...
Dear Experts, In 'sh ip flow top-talkers', source and destination port in hex format so it's really time consuming to understand the output. So can we do any change in configuration to convert the hex output into a decimal? or do you have any othe...
Meraki's default option for licensing is co-termination. So at the time of deployment, we used this method, but now we want to change the license method and use a per-device license method.So, is it possible?
Hello @ANAKIN_TN ,have you replaced the spine in your environment? If Yes, then please assist me by providing pre-requisite and instruction about replacement.Have you faced any problem like traffic loss while replacing the spine? What time required f...
Hi,Thanks for your reply.I have one question regarding L3Out.Do you know if I can connect AWS direct connect on Border leaf? Because AWS Direct Connect requires BGP configuration.
Thanks for your replyThis answer helps me to understand the whole process of IoT devices transmitting data and process it then we can easily read that data.But, I have two questions1) How I deploy LoRaWAN if I use Cisco IAV? Means what are the prereq...
