Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone!!!I have a little probelm configuring NAT on router 1841, like this is the topology: WAN (PUBLIC´S ADDRESS) fast0/0 fast0/0/0 PUBLIC´S ADDRESS INSIDE (192.168.1.0/24)ROU...
Hello Everyone, A few days ago, We configure a von between a router and asa, where the asa is ther server and the router is the remote client, who takes the public´s dhcp address.In the remote client i have two subnets (192.168.6.0/24 and 192.168.8.0...
Hello Everyone!!!I had a little problem with the ASA 5520 with 8.2(3)!!This appliance had been working fine since one moth ago, but the last week the ISP did some changes in the E1 and we have some problems with the connection to Internet, but this p...
Hello Everyone!!I have a VPN Client that connect with the Office, the vpn works fine. Right Now all the traffic including internet´s access goes through the tunnel. I would like to separate this, I know that i can use a split tunnel, but does not wor...
I just configure an ASA 5520, here is the config (the ip address of outside network if going to change from private direccion by reason security).The problem that I have is the users can access to the web site through the public´s ip address but they...
Of course marwanshawi, Like this is the topology, as the public address does not match the pattern for safety.Like I said before the client have a metro ethernet that comunicate with internet, but they does not have any firewall that can do the nat, ...
Thanks Raga, I make that test and still doesnt work, Here the output the show crypto ipsec sa on ASA:ASAMPC# sh crypto ipsec sainterface: outside Crypto map tag: DYN-MAP, seq num: 1, local addr: x.x.x.x local ident (addr/mask/prot/port): (192...
