Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone
i have an issue of automatic failover of vpn s2s .
i have a client has 2 peers one primary and the other is backup , if the first fails and second takes its place instead.
my senario is when the primary fails , the secondry stays at (UP-I...
hi
i have an issue with nat i need to solve
i have two servers that they are natted to two public IPs
let say 192.168.1.1 to 1.1.1.1
192.168.1.2 to 1.1.1.2
i want them they can connect to each other by public IPs
when 192.168.1.1 pings to 1.1.1.2 the...
hi
I have a scenario where I have 2 ISPs and they both have default route
route ISP1 0 0 1.1.1.1 1
route ISP2 0 0 2.2.2.2 2
i need network 192.168.1.0 to go out with ISP2 not ISP1
how can i do this in Cisco ASA
Best Regards,
Hi everyoneI have this confusing problem with clustering two FTD 4100 series, when copying the cluster configuration from the first one to the other one, it stays at this state all the time and not give even an errornotice that I have both FTD have 2...
yes i have IPsec SA for the secondry peer, but no caps, it stays at IDLE_UP state
until i delete the primary peer from the crypto map, then the secondary immediately goes up
i have checked that command : show crypto ikev2 sa de , and the primary peer completly dispeared only the backup peer with state IDLE_UP
this senario is true production , we made this senario with client and they asked for a check if the first peer d...
Hi
what i mean is when the primary peer is down , the second peer still stays at IDLE_UP state, what it should happen it should change to the second peer automatically, but it's not.
