Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have built a new Cisco Catalyst 9300 switch stack consisting of four switches. The order they came up is on the left but the order I want is on the right. Can I change the order through IOS commands and not remove and restack the switches? The s...
I have inherited a network that has Catalyst 3750's stacked with the data cables, but the power stack cables were not installed. The stacks have only two switches per stack and only one power supply in each switch. Essentially no power redundancy. ...
I have two Cisco Catalyst 9200's that are stacked. We no longer need them stacked and wish to split them. One switch will stay in production and the other will be reassigned later. My thought to do this would be to power down the one switch no lon...
I am having difficulty with deploying VLAN's. I will add a VLAN to a trunk port on both sides using the configuration command "switchport trunk allowed vlan add ...." and I can see that it has been added to the trunk, but when I do a "show vlan" its...
Would that command be used on the switch I remove to set it back to defaults?Also, would the switch that remains in production think it is still in a stack, and would need some type of reseting or "undoing the stack" commands?
I know I should’ve put more information. These VLAN’s are already in existence on our network and are in production and are configuration is four or five VTP domains each having a server ondistribution switches and clients are the access switches. Ab...
