About Dominik_

Dominik_ · 05-08-2022

Hi SDA-Experts, shortly to the environement: we have an SDA Fabric in our Location. We use the Catalyst C9300-48P as Access Switch. Our actual version is the 17.3.4 (which was the recommended at this time) Now we recently had a case on our end wh...

Dominik_ · 06-25-2021

Hey Community, I deployed a 9800-CL to an internal network. It was provisioned with the .ova file. In total i have 3 interfaces the plan was: Gi1 -> Wireless Management as Access Port Gi2 -> VLAN for SSID as Access Port Gi3 -> Redundancy Gi1 was r...

Dominik_ · 07-07-2021

Issue is solved. Key of our problem was that promiscous mode was not enabled. Now Cluster is up and running and serving clients. @Scott Fella "these are hard set for a specific use. Management and wireless management is on G2 unless you for some re...

Dominik_ · 06-25-2021

Ok - we reset the setup as follows: Gi1 disconnected Gi2 Access Vlan 123 Even in that way i don't get any traffic towards the SVI of the controller.

Dominik_ · 06-25-2021

Hi Scott, is it possible to reuse the Gi1 in that case? - i don't want to use it for OOB. Basically we have three vswitches Vnic1 -> Uplink to network (used as Wireless management) Vnic2 -> Uplink to SSID-network Vnic3 -> SSO

Member Since	‎06-25-2021 07:23 AM
Date Last Visited	‎06-16-2022 12:32 AM
Posts	5
Total Helpful Votes Received	1

User Statistics

User Activity

Onboard Packet Capture SDA

9800-CL with VLAN Interfaces - No Communication possible

Re: 9800-CL with VLAN Interfaces - No Communication possible

Re: 9800-CL with VLAN Interfaces - No Communication possible

Re: 9800-CL with VLAN Interfaces - No Communication possible