Hi SDA-Experts,
shortly to the environement:
we have an SDA Fabric in our Location.
We use the Catalyst C9300-48P as Access Switch.
Our actual version is the 17.3.4 (which was the recommended at this time)
Now we recently had a case on our end where we wanted to capture multicast traffic for one of the attached devices.
Since it is a quite remote location we wanted to use the onboard capture of the C9300.
So we added the Trace like this:
monitor capture [CapName] file ring 3 size 100 location flash:[CAPNAME].pcap interface [,...] both match any
But from the capture itself I only see incoming traffic. So from the device to the switch. Everything which is
VXLAN encapsulated to the device is not visible here. We did a workaround to capture the Uplink and decoded VXLAN in the capture. But for switches with high traffic beside the one we want to capture this is not feasible since we get a big load of data that we don't need...
Anybody has some tip how to get all the traffic? Or is the only way to do a span session?