Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, does anyone know how to send a ENTER (or Carriage Return for you guys who are oldschool) when using the CLI-tool in ASDM 6.4? I need to confirm a previous command with Carriage Return but that doesn't work only by hitting Carrige Return in th...
Hi,I have a ASA5550 sw 8.4(1) on which I have to do some "cleaning up" I'm using ASDM 6.4(1) for this.So, the interfaces (Gi1/1) got an ip-address, a security level and a interface name which i want to remove so that the interface has no ip, name an...
Hi,I have had some of the same trouble when trying to route traffic between vlan-interfaces on the ASA5550 platform. If I got a vlan10 and a vlan11 with different link local addresses on each vlan interface, traffic will not pass. If i change the lin...
Hi Poonquzhali,Yes, ones in a while we all have to do some clean up right ? Before you removed sec, nameif, ip add....did you also shutdown the interface or did you clean up on an active interface? Just corious Thanks for your fast answer-Jesper
Hi Mike, after shutting down gi1/1 I did run the clear config interface gi1/1 command and it work perfectly. The subinterfaces wasn't touched. Everything is up'n'running.Thanx again !
