Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know you tie access-lists to a time-range on the IOS, I have looked on how to do it on a PIX and this feature does not seem to be supported. Am I right?
Peering up my PIX (6.2) with another company's Checkpoint 4.1 for a VPN connection. One problem - the tunnel only comes up if the traffic is initiated by the Checkpoint (obviously, I can't see the config) and then everything works fine. If my PIX t...
I have a 10.x.x.x network on the inside interface (100). I have semi-rogue network being hooked up to ethernet6 (90) which is going to be 10.y.y.y. I would like for the 10.y.y.y network be able to see all the servers on the inside with the origin...
Would like to know if this can be done.10.x.x.x-------PIX--------Internet VPN Tunnel-------VPN router-------10.x.x.xI need to create a VPN tunnel to a partner company. I am on the PIX side. Our internal networks are both using overlapping 10.x.x.x s...
thank you. My peer has his lifetimes enables globally to almost 14 days. I have tried to set the PIX to the same value, but found out that 86400 is as high as you can go - is this a security feature than cannot be overriden?
Need more info on your situation, but assuming your outside interface is connected to the Internet - several things:1 - packets just do not "just go" from a higher interface to a lower interface. They have to be natted. If your inside network can a...
I think you can. Just go into User Tracking. Then, discover the devices mac addresses for a particular switch ( post again if you need help with how to do that and I will answer). It will show you all ports that have a MAC on it (be sure to delete...
