Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've resently been given the requirements to limit user access to certain functions within ACS so that they are only perform certain configuration tasks. Mainly just the basic port and vlan configuration tasks and not trunk/vrf/vss configuration. T...
I have some network monitoring servers that are using snmp/icmp to monitor devices on the network. The icmp functions are not used but can not be turned off on the application so are blocked on the firewall. This is filling the logs on the ASA with...
Just upgraded the dram to 192mb install 32(48)mb flash and installed the bootrom 12.2(8r) to support the memory. when i type show c2600 i can see the 2 memory modules in the slots 1x 128mb and 1x64m but when i type show ver or show hard it only lists...
Thank you for the reply Joseph. There is a trial version of LMS 4.0 on the website and I'll get a test box built and lab it. Upgrading to 4.0 is likely to be perferred than replacing the 5.0 acs appliance.
LMS 3.2 doesnt support the device out of the box but I downloaded a device update for the software download section for the 3750x which got it working in ciscoview. Believe this was the update i used for ciscoview. Probably an update for the other ...
Thank you for the replies, if I understand this correctly the logging is automatic and can only be turned off globally. I can only turn it off for certain subnets as we know why that is occuring and we cant turn it off on the application, anything e...
I have a similar issue, needing to filter incidents depending on the time of day they occur, i'm using version 4.3 and this doesnt seem to be possible. Can any of the later versions do this?
