Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I have two site linked by VPN with ASA 5525-X.In site A we have management network (172.16.30.0/28) where we have management ip of ASA 5525-X IPS (.172.16.30.14) and IPS (.172.16.30.13). The IPS has a default gateway interface vlan ip of bakbo...
Hi i have an existing vpn between two sites.The vpn is up and trafic pass.Now i have a second netwok to join on the remote site.and i want to add the new network 10.2.1.0 in the vpn.I have done the configuration but i have the following error with pa...
Hi I have two site linked by vpn ipsec site to site.I have in each site an ASA 5525-X with ips module.I have installed my FMC in the site A in a vlan with ip 172.16.30.12/28.The ASA management interface and ips module have ip too in the same vlan.all...
Hello, I am new to the FMC firepower management center. I just have a question about the nat policies. I use an ASA 5525-X managed by my FMC. When creating the nat policy, I must choose Firepower nat or FTD nat and what is the difference between the ...
HelloI have a problem to manage the devices of two sites. I have my FMC installed on the main site with a management network 172.16.30.0/28. The FMC has an address in this network as well as the ips module and the interfaces of management of ASAs. My...
HIIf I understand correctly, this command must be executed so that the traffic from the management interfaces goes through the tunnel. And for the ips module, there will be no routing problems.
