Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a stratix 1783-MMS10EA switch with the IOS s5800-universalk9.17.09.01.SPA.bin. I would like users to authenticate in 802.1x. However, when I apply 802.1x, the IP phone authenticates well and is placed in the right vlan but does not retr...
Hi,I am building an MPLS over FlexVPN infrastructure.In summary, on each site I have 2 public ISPs and private point-to-point links between each site in full mesh..I started by testing this in PSK and it works fine. I then installed certificates on t...
Hi,I am setting up an MPLS over FlexVPN infrastructure.FlexVPN and BGP work well as NLRIs are well received via VPNV4. However, these networks in the VRFs fail to communicate because the labels are not installed in the MPLS forwarding table.Attached ...
Hello,I am working on setting up an MPLS over DMVPN infrastructure with spoke to spoke tunnels (phase 3).According to the theory, we just need to replace the MPLS IP command used when we are in phase 1 (Hub and spokes) by MPLS NHRP or mpls bgp forwar...
MPLSHi all, Not having had any feedback regarding my question on the subject covered in the link: https://community.cisco.com/t5/routing/mpls-over-dmvpn-traffic-engineering/m-p/4435095#M353137probably because the subject was considered closed, I reit...
Hi MHM,Below is the requested result.Regards,Chris sh authentication sessions int Gi1/8 detInterface: GigabitEthernet1/8IIF-ID: 0x1E605D82MAC Address: 487a.551e.929fIPv6 Address: UnknownIPv4 Address: UnknownUser-Name: ALCIPTStatus: AuthorizedDomain: ...
Hi Joshqun,I have already checked option 82 and I had also tested the authentication control-direction command in but it did not change anything. And for information DHCP works well on PCs, it is just on phones that it does not work for this switch m...
Before the networks in the VRFs could not join each other. My mistake was to use OSPF to route loopbacks for BGP peering. But in this type of topology we don't need OSPF. When I removed it and mounted the BGP peering directly with the Tunnels interfa...
