Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX to PIX VPN established. I can ping back and forth from client to client on their respective network over the VPN. I can get DNS resolution over the VPN. I can even login to a domain across the VPN, however I cannot seem to get any por...
Hello,I have a PIX 515 and a PIX 506 both connected via broadband to the internet. I have setup a VPN configuration between the two but am having some trouble getting traffic from clients behind either one to the opposite side clients respectively.T...
I have a 515 and 3 501's. I currently have 2 VPN's running fine. I am having a bit of a time getting the 3rd VPN up. I did verify that the same key is being used for both configs. I know I'm missing something simple here, but I cant seem to see i...
I have a 501e that I'm really suspicious of. I have several locations with 501e's, and I had previously set this one up at a location and had connectivity issues, when I changed firewalls, I also changed configs so I was unsure if the firewall in qu...
Hello all,I am in the process of setting up an email server, for the time being for reasons I'd rather not explain, I cannot put it on the DMZ. So it is sitting on the inside of the 515e firewall interface.I have the internal IP of that server as 19...
I still have not resolved this issue, i need help.I ran a port scanner across the vpn. I get 2 ports back, 25 and 110. If i try to telnet to those ports i get a blank telnet screen. The IP that im telnetting to should not have email services on it...
After Further review...(i know, im answering my own post)...I think actually the problem lies with the command in the 515 config witha route command that I somehow didnt include in the original postroute outside 0.0.0.0 0.0.0.0 x.x.x.97 1route inside...
Thats a great link, i learned a good bit just reading through that, but ... alas....:)Ok, here's the deal, on that debug link, it says according to my debug, >>>>"The message below appears if the Phase II (IPSec) doesn't match on both sides. This mos...
