Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My sales rep is telling me that there is an unrestricted user upgrade for a cisco pix 501 but according to the following cisco link there doesn't appear to any such beast. Is there another link someone could send me to clarify this a little bit.http...
Assuming that I simply have two 350 wireless bridges between two subnets 192.168.1.x and 192.168.2.x with no routers whatsoever what IP information should I be entering in the client PC's to connect with the other side. I was thinking that changing ...
When I set this up at a client site as I recall you can only use the non-root bridge as an AP. You aren't by any chance trying to use one bridge as an AP are you? If you are I'm not sure that you can set one unit as a non-root bridge without havin...
Well I have no routers to speak of. They use a proxy server to get to the internet. My more specific question is even if I manage to put a router in each location the bridge will only hear broadcast arp messages to relay them to the other side (or ...
I think that the maximum you are referring to is the tested throughput seen on various 802.11b equipment. With the bridge links the main difference in throughput seem to be distance and obstacles as far as I've seen. I've tested the throughput in m...
Just to add to the confusion I have also used putty (ssh client) from outside and also expierienced the same sort of lockup. We were trying to change the ip address of the vpn peer and whenever we put the no command in it would freeze up and require...
I think you may be able to do this using some debug commands. As I recall when I am trying to troubleshoot the vpn setup one the debug commands gives me setup and teardown information. Then using the syslog functionality I think you can output the ...
