Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to converts ports from Ethernet to FC on UCS but the slider is starting from left to right instead of right to left. Is this the new firmware?.
Hi, I am running the topology below with EVPN/VxLAN Multisite on dcloud. Unfortunatley the two hosts in different sites and different VNI could not ping each other. However same VNI different sites the can ping each other and also different VNI same ...
I have a SVI configured as below on the Nexus 7K, client want the VLAN to be migrated to ACI. How do I setup policy based routing in ACI?. interface Vlan403description ##### PABX #####no shutdownvrf member SNLno ip redirectsip address 10.18.1.2/24no ...
It is possible....You configigure two L3out Pod1_L3out and Pod2_L3out.Configure BD1_Pod1 and BD2_Pod2. Each BD will be have an EPG configured for node interface for servers in there respective Pods only. BD1_Pod1 will be assocated with Pod1_L3out an...
"VxLAN act as the Overlay Data Plane. Then where you see VxLAN Network Identifier "VNI" this is the Overlay part." the UDP and SMAC/DMAC/SIP/DIP are VTEP PIPs. Why are they marked as Underlay? I thought that's the overlay and payload encapsulated ins...
Hello,When you replace an active APIC with a standby one, the replaced APIC switches off but does not wipe its configurations, as you previously explained. I have performed this procedure a couple of times in production. While switching on the replac...
